• Model NO.: WG96
  • Power Supply: Rechargeable Battery
  • Charging type: Rechargeable
  • With Light Source: With Light Source
  • IP Rating: IP68
  • Surface Preparation of Reflecting cup: Smooth
  • Certification: CE, RoHS
  • Bulb: Sst-90 LED(Max 2200 Lumens)
  • Color Temperature: 6000 K
  • Lens: 8mm Polycarbonate Board
  • Angle of Light Beam: 8° Hot Spot, 110° Periphery
  • Dimensions: 213.5mm (Length)* 78.0mm (Dia. of Head)
  • Transport Package: EVA Gift Packing.
  • Origin: Shenzhen of Guangdong
  • Usage: Underwater 100 Meters Diving Flashlight
  • Switch: Magnetic Switch
  • Runtime: >6H
  • Battery Type: Lithium Battery
  • Material of Reflecting cup: Metallic
  • Material: Aluminum Alloy
  • Model Item: Wg96 Diving Flashlight Torch
  • Operation Voltage: 9V to 13V
  • Reflector: Glossy Aluminum Reflector
  • Body Material: Durable Aircraft-Grade Aluminum
  • Battery: Rechargeable Li- Ion Battery Pack (18650 Battery*6
  • Trademark: ARCHON
  • Specification: CE, RoHS
  • HS Code: 85131010
Product Specifications:
 
Model Archon New Model WG96 Flashlight Rechargeable
 Bulb SST-90 LED *1 (max 2200 Lumens)
 Color temperature  6500 K (white light)
 Reflector  8° hot spot,110° periphery
 Lens  8mm Polycarbonate Board;
 Battery  18650 rechargeable Li- ion battery *6;
 Battery Indicator  100%-50%: Green; 50%-30%: Yellow; 30%-10%:
     Red; Below 10%: Red Flashing; Below 5%: switch off;
 Protection Polarity reversing protection. 
Gas release valve

BATTERY CHARGING
1. Plug the charger in the wall power socket, the indicator light is green
In the free-load status.
2. Plug the port of the charger in the ports on the light. (the positive and
Negative polar doesn't matter, both ways work. )
3. The indicator light on the charger is red if the battery is not fully
Charged; It will turn green after fully charged.
4. Take out the charger and use the light.

ON/OFF
Push the switch to turn it ON.

MODES CHANGING
Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF.

SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION
Please put the switch sleeve on light head during transportation to prevent it from misoperation.

If the switch gets stuck, please put some washing-up liquid in the slot of the switch and push the switch back and forward several times till it move smoothly again, then clean the light in the fresh water.

Please charge the light every time after using. If it isn't used for a long time, please charge the light once every 3 months to prepare for next time using.

Optical Fiber Passive Components

Optical Fiber Passive Components,High Quality Optical Fiber Passive Component,Electronic Components & Supplies, Fibre Optic Passive Components

Optical test instruments,Fiber Optic Equipment Co., Lt d , http://www.nbopticfiber.com